[求助]Twyman-Green.ZMX怎么在Detector Viewer 里看不到干涉条纹图啊？ [复制链接]

ZEMAX自带的非序列干涉仪例子：Twyman-Green.ZMX 怎么在Detector Viewer 里看不到干涉条纹图啊？如果想要得到干涉条纹图，该怎样调整修改？ CsQ}P)  
@)M.u3{\  
请各位高手相助！谢谢！ }~0{1&  
8)2u@sx%  
Twyman-Green.ZMX 文件路径：ZEMAX / Samples / Non-sequential / Ray splitting / Twyman-Green.ZMX

实在没有人指点，恳请版主出来相助！

自己顶一下, 再次希望版主相助! 非常感谢!

zemax不能看干涉衍射现象吧，只是几何光线追迹啊

you could check the following: )}Mt'd  
3_['[}  
- if the surface/element tilt is too large pLFL6\{g  
wz2)seZY  
- enough analysis rays used? ;?[+vf")  
doU
qUak  
- have you used Coherent Data option under Detector setting. kA$;vbm  
LHGK!zI  
Someone above was right about that the non-sequential mode only uses geometric rays but you could see inteference fringes using Coherent Data.

非常感谢楼上的回复!