[求助]PW法计算出初始结构，在zemax不能追迹光线 [复制链接]

PW计算出初始结构，放到ZEMAX不能追迹光线，这是为什么呢？ dQA'($  
l:,'j@%  

图片:QQ截图20141028115618.jpg

QLiu2U o  
<(fRn`)PT  

图片:QQ截图20141028115628.jpg

1;Cyz)  

you might need to tweak the surface semi-diameter/radius a bit to make rays traceable towards the image plane. your calculation based on PW method is an approximation I would assume, so make a little change to start with for few cycles of optimization then you should be able to get around the problem.  

hopebox:you might need to tweak the surface semi-diameter/radius a bit to make rays traceable towards the image plane. your calculation based on PW method is an approximation I would assume, so make a little change to start with for few cycles of optimization then you .. (2014-10-28 19:56)  {5U{8b]k  

0QXVW}`hz  
Thanks for your anwser! But new problem come up.I have choosen "Afocal image space",但出射光并不平行，反而汇聚到一点，这是为什么呢？ -3t7*  
8=B|C'>  
英语不好 LOL

Check the following: dpAjR  
PWaw]*dFmy  
General > Aperture (did you tick Afocal Image Space?) mXRB7k  
3GaQk-  
Once you do so, make use of Default Merit Function and select Angular Radius option. Read a bit more from the user manual about this option would be helpful!

咏物词:Thanks for your anwser! But new problem come up.I have choosen "Afocal image space",但出射光并不平行，反而汇聚到一点，这是为什么呢？
英语不好 LOL (2014-10-28 20:21)  %7"q"A r[  

\a5U8shc  
Sorry, forget about checking the Afocal Image Space. You did so already! My apologies!

hopebox:Check the following:
General > Aperture (did you tick Afocal Image Space?)
Once you do so, make use of Default Merit Function and select Angular Radius option. Read a bit more from the user manual about this option would be helpful! (2014-10-28 20:32)  `{eyvW[Ks  

Wl;.%.]>  
awesome！thanks a lot！ :j5n7s?&=y  

hopebox:Sorry, forget about checking the Afocal Image Space. You did so already! My apologies! (2014-10-28 20:33)  $h^wG)s2P  

#?5 (o  
You are really awesome！The problem is solved，thanks a lot！

No prob!

一帮大神啊

我是来膜拜的