| hopebox |
2010-06-10 21:36 |
Allow me to repost here for depth/frequency setting D` cy.},L
The main fresnel lens types are: 0wqw5KC
U74L:&y LI
* Constant groove depth. +6+1N)L
* Contant groove pitch types. 2\64~a^
%sZ3Gpi
So if your depth is fixed you will define +ve value in the cell and to specify the "height" or "depth" of each groove feature. If the frequency of the groove is fixed then you use -ve value. Say putting down - 5 this implies that there are 5 grooves with a unit length. 8 * m,#
3zfiegY@wm
For radius, this is the curvature of the base surface. If you define one such lens and chaneg the radius and you shall see what it means. A graphic tells lounder than words. ]o'dr
r
hqHk,#
For conic: check conic section using Wikipedia and you should see what conic constant means. 1bw$$QXC_
Y*lc ~X
wS$ 'gKA6
|
|